Mounting air compressor in a toolbox

I did not want to mount my compressor under the hood (too hot) and it was too big to mount behind the rear passenger tail light. I decided to mount it in a toolbox. Here was the process.

This is the toolbox I will be using.

This is how it will look inside the tub.

Perfect place to mount it to the tub - this hole runs all the way down to the rear spring mount.

I'll be running this bolt.

Bolt fed through the hole.

Bolt cut down .

Hole in toolbox to run bolt through.

For extra security and durability I added some steel plate that I had laying around.

I am going to use longer black screws I found to mount the mounting plate to the toolbox.

Mounting plate is mounted.

Compressor mounted.

Rubber washer.

Finished. Now I just need to wire it to the battery, but it already works with just the terminals.

HID Kit install on a JK

This is the connector that goes from the stock headlight wiring to the ballast.

This is the HID bulb.

This is the kit. The blue things are the ballasts.

I removed the grille. Had to loosen the bolts on the winch to do so.

Aftermarket horn is in the way!

This is an H13 male adapter that I bought.

These are the leads that plug into the male adapter. (leads from the kit that go to the ballasts). I soldered them on.

The male adapter is connected and a capacitor is added on. This is the link to the capacitor I used: http://www.radioshack.com/product/index.jsp?productId=2102508 I
I used electric tape to tape around the capacitor and wiring to weatheproof it.

The lights work and do not flicker.